Fiber Optic Transmitter/Receiver & Repeater Board

Specs

Channels:  2 transmit channels, 2 receive channels.

Optical:  To be used with 1000 micron plastic fiber optic cable.  Fiber distance should be limited to 40 meters unless special low-loss fiber is used. These units can be used as repeaters to go greater distances.

Electrical:  Electrical signals to be transmitted are TTL compatible. Received signals are converted to TTL and can drive loads of 50 ohms maximum.

Power Req.:  5-24Vdc.  If +5 Vdc is used for power, the voltage regulator is not needed. Note:  Voltages above +5 Vdc will cause a fair amount of heating on the voltage regulator.

I/O Interface:  10 terminal plug-in terminal strip for all signals and power.

Physical: Approximately 2.5″ X 2.75″.

Mounting: Can be mounted with stand-offs or DIN-rail custom circuit module.

Cost

P/N 0000-002, $195. Price is dependent on quantity and is subject to change at any time without notification.