Inexpensive RS-232 to Fiber Optic Converter

Specs

Description: A simple and inexpensive RS-232 to fiber optic converter.

Channels: TX and RX only. Solder holes are available for each of the nine DB-9 signals if jumpers are required.

Optical:  To be used with 1000-micron plastic fiber optic cable.  Fiber distance should be limited to 40 meters unless special low-loss fiber is used.

Power Req.:  + 5Vdc or higher (on-board regulator) via plug-in terminal strip.

Physical: Approximately 2.0" X 3.0".

Cost

P/N 0001-013, $125. Price is dependent on quantity and is subject to change at any time without notification. Note that two are required to complete a fiber optic RS-232 link. Only one is required if interfacing to an Answer Man Junior I/O Board.

VISA, MasterCard, and AMEX accepted.

Home  

For further information contact Neal Pederson at np@vicontrols.com
VI Control Systems Ltd., 2173 Deer Trail, Los Alamos, NM 87544
Tel: (505) 662-1461, Fax: (866) 422-2931

 

Designed and Created by VI Control Systems Ltd.
Copyright 2005 All Rights Reserved.